MilliporeSigma

Calcium in Beer

Photometric determination with phthalein derivative

Instruments and Reagents:
Cat.No. 173016  Spectroquant® VIS Spectrophotometer Prove 100 or
Cat.No. 173017  Spectroquant® UV/VIS Spectrophotometer Prove 300 or
Cat.No. 173018  Spectroquant® UV/VIS Spectrophotometer Prove 600 or
Cat.No. 114946  Rectangular cells 10 mm and/or
Cat.No. 114947  Rectangular cells 20 mm and/or
Cat.No. 114944  Rectangular cells 50 mm
Cat.No. 100049  Spectroquant® Calcium Test
Cat.No. 116754  Water for analysis

Sample preparation:
Fill 100 mL of beer in a 600 mL beaker. Stir in order to drive off the CO2 for about 1 hour with a magnetic stirrer. Alternatively you can use also an ultra sonic bath. Attention! Foams strongly.

Beer Glass

Dilution steps:
Samples containing higher than 4.00 mg/l Ca must be diluted with water for analysis according to the following table:

Therefore pipette x mL of this solution into a 100-mL volumetric flask and fill up to volume with water for analysis to the mark
(= diluted beer sample).

Analysis:
Determine the CA content with the above mentioned test kit against a reagent blank (water for analysis (instead of beer) + reagents).

The method is preprogrammed on the Prove instruments, but has to be calibrated for each batch.
For details see Prove manual.
It is recommended to perform a calibration with 5 - 10 measurement points over the entire measuring range.
The calibration should be checked regulary using standard solutions.

Materials
Loading
Sign In To Continue

To continue reading please sign in or create an account.

Don't Have An Account?